Signature Hardware ENGEL TRIPLE CORNER SHELF Installation Instructions

ENGEL TRIPLE CORNER SHELF INSTALLATION

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing this type of product. Signature

Hardware accepts no liability for any damage to the

product, mounting surface, or for personal injury during

Observe all local plumbing and building codes.

Unpack and inspect the product for shipping damage. If

any damage is found, contact our Customer Relations

team at 1-866-855-2284.

Ensure that you have gathered all the required

materials that are needed for the installation.

Phillips

Flathead

Screwdriver

Level

Tape Measure

Engel Triple Corner Shelf Installation Instructions

SKU(s): 916691

Drill

Pencil

Table of Contents

Do you have a question about the ENGEL TRIPLE CORNER SHELF and is the answer not in the manual?

Page 1: Before You Begin
Unpack and inspect the product for shipping damage. If any damage is found, contact our Customer Relations team at 1-866-855-2284. Level Tape Measure Pencil GETTING STARTED Ensure that you have gathered all the required materials that are needed for the installation. Engel Triple Corner Shelf Installation Instructions...
Page 2 4” or 5” from the corner, as you did in step line on both walls along both edges of the shelf. 3. Mark the location where each of these two lines cross, on each wall, as shown below. corner corner 9¼” 9¼” 4-5” 4-5” Engel Triple Corner Shelf Installation Instructions...
Page 3 See below. makings from the wall. Important: If drilling through tile, ensure that you use a masonry drill bit and drill slowly to avoid cracking. bracket top bracket bottom upper middle lower Engel Triple Corner Shelf Installation Instructions...
Page 4 ﬁt into the seats on plastic set screws on the bottom of each bracket. each bracket. Rearrange the brackets if needed. Once in position, ﬁnish tightening the shelf bracket screws. Engel Triple Corner Shelf Installation Instructions...

916691