Crankshaft, Piston And Cylinder - Husqvarna 335XPT Workshop Manual

CRANKSHAFT, PISTON AND CYLINDER

Dismantling
Dismantle the following parts:
1. Chain and bar. See the Operator's manual.
2. Centrifugal clutch. See page 23.
3. Muffler. See page 16.
4. Carburettor. See page 27.
5. Starter. See page 19.
6. Ignition system and spark plug. See page 21.
7. Tank unit. See page 33.
NOTE!
Ensure that no dirt or other foreign particles fall into the
dismantled components.
Continue to dismantle the piston and cylinder as follows:
8. Dismantle the four bolts (A)
9. Dismantle the cylinder.
10. Dismantle the crankshaft from the crankcase.
11. Remove one of the piston's circlips, press out the gudgeon
pin and remove the piston.
12. Remove the needle bearing from the little end on the
connecting rod.
13. Dismantle the manifold pipe (B) from the cylinder.
14. Dismantle the bearing (C) using the puller 504 90 90-01.
38
– English
A A
C
A
A
B
C