Table of Contents
Advertisement
Assembly
Assemble the parts as follows:
1.
Connect the electrical connection to the lock plate (E) and
choke lever/throttle (J).
2.
Slide in the throttle (H). At the same time fit the throttle rod
(I) on the throttle. Do not hook it onto the bearing (F) yet.
3.
Using thin-nosed pliers fit the lock plate (E). Secure using
screw (D).
4.
Slide up the choke lever/start control (J).
5.
Fit the pin from the right-hand side (C). The press down the
throttle lock (A). Check that the lock's locking arm goes
down into the cut-out in the throttle and fit the pin (B).
6.
Hook on the throttle bearing (F). Use a screwdriver to fit the
choke rod (G) on the carburettor.
7.
Fit the clutch cover and carburettor cover. Adjust the chain
tension, see the Operator's manual. Tighten the clutch
cover nut to 15 Nm.
8.
Check the stop function by starting the chain saw and make
sure the saw stops when the stop button is moved to the
stop position. See the Operator's manual.
18
– English
SAFETY EQUIPMENT
J
I
E
F
B
C
D
F
G
E
H
D
A
Hide quick links:
Advertisement
Table of Contents
