Husqvarna 335XPT Workshop Manual page 20

Cleaning and inspection
Clean the parts and check as follows:
1. Starter cord.
2. The dogs in the starter pulley.
3. That the pawls on the flywheel are OK, and spring back
towards the centre and move freely.
Assembly
1. Lubricate the new recoil spring using thin oil without taking
it out of its housing.
2. Carefully fit the spring housing in the starter housing so that
the spring does not fly out and cause personal injury.
3. Insert and attach the new starter cord in the starter pulley.
Wind on approx. 3 turns on the starter pulley.
4. Fit the starter pulley against the recoil spring so that the
end of the recoil spring hooks in the starter pulley. Fit the
bolt in the centre of the starter pulley.
5. Pull out the starter cord through its hole in the cover and fit
the handle, secure with a double knot.
6. Lift up the starter cord from one of the cut-outs in the starter
pulley and turn the starter pulley approx. 2 turns clockwise.
Check the cord tension:
A. Pull out the cord completely.
B. In this position it should be possible to turn the starter
pulley by hand a further 1/2 - 3/4 turn.
7. Fit the starter on the chain saw. Pull the starter handle
slightly until you feel the starter dogs grip. Now fit the four
bolts and tighten to 2.5-4 Nm.
20
– English
STARTER