Table of Contents
Advertisement
From Handset to Handset:
•
Press the INTERCOM key followed
by the number of the other Handset
you wish to call (e.g. INTERCOM 3).
•
Handset 3 can then answer the
intercom call by pressing the
INTERCOM key.
•
To end the intercom call press OFF
on either Handset.
NOTE: If only one Handset is registered, the LCD will display "Feature Not
Available" when INTERCOM key is pressed.
Global Page
•
Press INTERCOM. Then scroll down to GLOBAL PAGE. Press OK.
•
Any Handset can answer by pressing INTERCOM.
•
To end the intercom call press OFF on Handset.
Handsfree Speakerphone Operation
Your v 2656 Handset has a built-in handsfree speakerphone. This feature
allows you to stand the Handset upright on a table or desktop and have
handsfree conversations. For more information, refer to MAKING CALLS in
HANDSET AND BASE OPERATION.
Switching between the Handset Earpiece and Speakerphone
If you are using the Handset earpiece, press SPEAKER to continue your call
using the Handset Speakerphone.
To return to the earpiece, press SPEAKER again.
In Use Indication
On the Handset:
When the telephone line is currently
being used by a v 2656 Handset, a
status message similar to this will display
on idle Handset(s):
When the telephone line is currently
being used by a parallel set (a telephone
device other than the v 2656 on the
same line); the phone icon will remain
on steadily, and EXTENSION IN USE will
be displayed.
On the Base:
When the telephone line is currently being
used by a v 2656 Handset, the IN USE LED
on the Base will illuminate steadily.
When the telephone line is currently being used by a parallel set (a telephone device
other than the v 2656 on the same line), the IN USE LED on the Base will flash.
When the answering system answers a call, the IN USE LED on the Base
will flash, too.
91-005358-050-000 v2656.pmd
Handset and Base Operation
24
24
8/5/2004, 4:51 PM
Advertisement
Table of Contents
