Sedan/Coupe With Antenna Placed At The Rear Of The Roof; Sedan/Coupe With Antenna Placed At The Front Of The Roof - Sirius XM RAdio Tour SXWB1V1 User Manual

Installation

Sedan/Coupe With Antenna Placed at the Rear of the Roof:

1. Feed the antenna cable from the antenna underneath the rubber molding around the rear
window . Use a blunt plastic putty knife or similar blunt tool to lift the rubber molding around
the rear window and tuck the antenna cable underneath the molding . Route the antenna cable
around and down the window to the lowest point . If your rear window does not have rubber
molding, we recommend consulting a professional installer .
2. Route the antenna cable out of the window molding and into
the rubber weather stripping around the trunk opening . Lift the
weather stripping from the opening and tuck the cable inside
it, then replace the weather stripping . To avoid sharp bends in
the cable, run the cable inside the weather stripping for a few
inches, then remove the cable from the weather stripping inside
the trunk . Keep the cable away from hinges, gears, etc ., that
could damage it .
3. Route the cable out from the rubber weather stripping and along the trunk wall . Continue
routing the cable into the vehicle cabin through a conduit or along an existing wiring harness .
4. Route the cable through the main cabin area under the interior trim, towards the front of the
vehicle . Use a blunt plastic putty knife or similar blunt tool to lift the plastic trim just enough
to tuck the cable under underneath . Avoid side airbag locations on back pillars and above the
doors . Airbag locations are marked with "SRS" logos . Be careful not to crimp or cut the cable .
5. Bring the cable out from the trim near the front of the cabin and route it under the carpet
toward the dashboard or console . Coil any excess cable in a hidden location, such as under the
carpet, keeping it away from any vehicle pedals or controls . Secure the excess cable with wire
ties (purchased separately) .
6. Bring the end of the cable out at the PowerConnect Vehicle Dock location . Leave yourself
enough cable so you can easily connect it to the antenna connector of the dock .
7. Continue with
Adapter" on page

Sedan/Coupe With Antenna Placed at the Front of the Roof

1. Feed the antenna cable from the antenna underneath the rubber molding around the
windshield . Use a blunt plastic putty knife or similar blunt tool to lift the rubber molding around
the windshield and tuck the antenna cable underneath the molding . Route the antenna cable
around and down the windshield to the lowest point .
2. At the lowest corner of the windshield, route the cable out of
the windshield molding and into the rubber weather stripping
around the door opening . Lift the weather stripping from the
opening and tuck the cable inside it, then replace the weather
stripping . Run the cable inside of the weather stripping to the
bottom of the door opening .
3. Pull the cable out of the weather stripping at the bottom of the door opening and route it under
the carpet toward the dashboard . Coil any excess cable in a hidden location, such as under the
carpet, keeping it away from any vehicle pedals or controls . Secure the excess cable with wire ties .
4. Bring the end of the cable out at the PowerConnect Vehicle Dock location . Leave yourself
enough cable so you can easily connect it to the antenna connector of the dock .
5. Continue with
Adapter" on page
18
"Step 5: Connect the Magnetic Mount Antenna and PowerConnect Power
20 .
"Step 5: Connect the Magnetic Mount Antenna and PowerConnect Power
20 .
Tour with Vehicle Kit User Guide