Set Remote Access Code; Set Message Alert Tone - VTech LS6125-2 User Manual

Answering system

Set remote access code

A two-dgt securty code s requred to access the answerng system remotely
from any touch tone telephone. The preset code s 19. You can set the code
from 10 to 99.
To set the remote access code:
Press SET UP when the phone s not n use, untl the system announces the
1.
remote access code settng.
2. Press /SKIP or /REPEAT to change the remote access code by one, or
press and hold /SKIP or /REPEAT to change t by ncrements of ten.
SET UP to save the settng and go to the next settng, or press
to save and ext set up mode.

Set message alert tone

Ths feature programs the system to beep every 10 seconds to alert you of new
messages. The tone wll stop when all new messages have been revewed.
To set the message alert tone:
1. Press SET UP when n dle mode untl the system announces the message
alert tone settng.
Press /SKIP or /REPEAT to select on or off, then press SET UP to save
2.
the settng and go to the next settng, or press
ext set up mode.
/PLAY/STOP to save and
www.vtechphones.com
• The answerng
system must be
turned on for the
message alert
tone to functon.
Press Press
/PLAY/STOP
37