Installation
Check for dial tone
• If the phone will
not be used for a
long period of time,
Charge the handset battery
remove the battery
to prevent battery
damage
Language
Set the dial mode
8
After the batteries are charged, pick up the handset and press TALK/FLASH; you should hear a
dial tone If you do not, refer to the Troubleshooting section in the back of this user's manual
The battery may have enough power to allow for short calls If the battery power is low, NEEDS
RECHARGING will appear on the handset screen For best performance charge the battery for at
least 16 hours the first time.
• Press PROG, then press
• The current setting blinks Press
Espanol or Francais)
• Press SELECT to save your selection
If you have touch tone service, the phone is ready to use as soon as the battery is charged If you
have pulse (rotary) service, you'll need to change the dial mode
• Press PROG.
until the screen displays DIAL MODE: and the current setting
• Press
or
• Press SELECT. The current setting blinks
to select TONE or PULSE.
• Press
or
• Press SELECT to save
www.vtechphones.com
or
until LANGUAGE is displayed Press SELECT.
or
until the screen displays the correct language (English,