Normal Startup Sequence; Figure 27: Normal Startup Sequence - Canon imagePRESS Server F200 Installation And Service Manual

Verifying the system
T 1:
ABLE
Conditions to verify
Each cable required is:
• Present
• The correct type
• Installed in the correct connector
• Well-seated
• Not visibly damaged (including connectors)
If included in the system, the required mouse, monitor, and keyboard
are present and appear undamaged. The mouse and keyboard are
connected to the correct ports on the imagePRESS Server connector panel.
The cables required are:
• Present
• Installed in the correct connector
• Well-seated
• Not visibly damaged (including connectors)
Code in motherboard BIOS
1
initializes and configures
areas on the motherboard.
Power on
Activity light
blinks orange
3 seconds
T
ROUBLESHOOTING

Normal startup sequence

N : The following description is approximate. The screens, times, and sequences that you
OTE
observe may vary slightly.
Activity light
blinks green
25 seconds
Normal startup sequence
F 27:
IGURE
Part and additional page references
UIB cable, page 41
Hard disk drive data cable,
Copier interface cable,
DVD drive power and data combination cable,
Power cable(s), page 65
• Mouse (if applicable)
• Monitor (if applicable)
• Keyboard (if applicable)
• Monitor power cord (not pictured)
Windows operating system
2
establishes communication
with imagePRESS Server
devices.
Activity light
is off
2 minutes, 15 seconds
93
page 68
page 40
page 76
System software on the hard
3
disk drive completes startup
process. The imagePRESS
Server is at Idle.