Jumpers - Canon imagePRESS Server F200 Installation And Service Manual

R
EPLACING PARTS
4 Wait two minutes to allow the motherboard electrical components to fully discharge.
5 To insert a new battery, slide it into the socket so that the positive (+) side of the battery
faces front.
6 Press the battery down into the socket until it snaps into place.
Make sure that the battery is securely installed in the socket.
7 Reassemble the system and verify its functionality (see
8 Configure the time and date in Setup (see Configure Help for more information).
Failure to configure the time and date will cause the imagePRESS Server to hang when user
software is being installed on the imagePRESS Server. (See

Jumpers

Jumper configurations should not be changed.
Jumper Description
J4 J4 is the Clear CMOS and Password jumper.
Default configuration: jumper cap installed on pins 2 and 3.
N
OTE
motherboard components, the DVD drive, and the hard disk drive.
Pin 1
It is not necessary to clear the CMOS settings when servicing
:
page 78).
page 100.)
63