Connecting To The Copier And The Network; Figure 2: Straight-Through And Ethernet Crossover Cables - Canon imagePRESS Server F200 Installation And Service Manual

Connecting to the copier and the network

Connect the imagePRESS Server to the copier and the network to enable print and network
connectivity.
T
O CONNECT TO THE COPIER
1 Make sure that the imagePRESS Server and the copier are powered off.
2 Connect one end of the copier interface cable to the imagePRESS Server.
3 Connect the other end of the copier interface cable to the copier.
4 Connect the Ethernet crossover cable to the lower RJ-45 port on the imagePRESS Server and
the copier.
N
cable included with the imagePRESS Server look similar, but are not interchangeable. Make
sure that you connect the Ethernet crossover cable to the lower RJ-45 port on the
imagePRESS Server connector panel.
Align cables side by side
and examine wires.
F
IGURE
T
O CONNECT TO THE NETWORK
1 Make sure that the imagePRESS Server is powered off.
2 Make sure that the network cable is connected to the customer site network.
I H
NSTALLING ARDWARE
The straight-through network cable at the customer site and the Ethernet crossover
:
OTE
1 2 3 4 = 1
Straight-through and Ethernet crossover cables
2:
Straight-through cable:
wire arrangements are
identical on both connectors
2 3 4
Ethernet crossover cable:
wire arrangements
are different
19