KitchenAid KUD Series Technical Education page 22

6. Route the drain hose, as shown, and press
the hoses into the drain hose support.
Decide if the drain hoses need to be
trimmed. If so, trim them.
Slip a wire clip over each drain hose. Push
the hoses into the drain hose connector
firmly, 5 clicks.
Position the wire clips between the two
positioning ribs on the drain hose connec-
tor.
Attach the drain hose connector to the
waste tee using the supplied hose clamp.
Attach the drain hose support bracket to
the cabinet with a #8 phillips screw at the
height shown below.
drain
hose
support
27-1/2" – 32-1/4"
(70 cm – 82 cm)
2-12
waste
water supply
wire
clip
drain hose
connector
waste tee