Location And Function Of Parts And Controls - Sony DSC-1024HD Operating Instructions Manual

Location and function of parts and controls
[1J
ON/OFF (power) switch and indicator
Press to
tum
the
W'lit
on and off.
The indicator on the switch lights when the
unit
is turned
on.
III
COMMAND MODE selector
When using the remote commander supplied with the
Sony monitor or lV, set it to TV.
When using the remote commander supplied with the
Sony projector, set it to pJ.
When not using the remote commander, set to OFF.
@I
DISPLAY
ON/OFF button and indicator
Press this button to tum on the indicator (DISPLAY ON) to
display the current operating mode on the screen.
Press
it
again to
tum
off the indicator to eliminate the
display (DISPLAY OFF).
Note
The main menu
appears by pressing
the MENU button,
even if
the
DlSPLA Y OFF mode
is
selected.
L4J
TEST PA nERN
button and indicator
Press this button to
tum
on the indicator to display the test
pattern on the screen.
To
tum
off the test pattern, press the TEST PA ITERN
button repeatedly until no test pattern is displayed, or
press the ON/OFF, rNPUT SELECT or OUTPUT
FORMAT button.
lID
LINE DOUBLER button and indicator
When the input signal format
is
NTSC or PAL, press this
button to turn on the indicator and activate the line doubler
function. Press it again to
turn
off the indicator and cancel
the line doubler function.
3.0
c::Jc::J
- .~
[§]
OUTPUT FORMAT button
Press this button to select the desired output signal format.
The selected output signal indicator lights.
[1]
SIGNAL FORMAT indicators
SIGNAL FORMAT
IN
iii!§£JCillJIillE]ClliJ
~I]ill~
OUT JNTScll PAL
113' .5kJ~1I
48. 1164.
1I,080l!
L-GEN-lOCK
...J
IN indicators (upper)
Shows the
input signal fonnat that the unit automatically
detected.
31.5k, 37k, 48k and 64k indicate the horizontal scaruUng
frequencies. If the horizontal scaruting frequency of the
input signal detected is one of these values
±1
kHz, the
corresponding indicator lights. If another value is
detected, the OTHERS indicator lights.
OUT indicators (lower)
Shows the output signal format
selected by
the
OUTPUT
FORMAT button. The output signal format shown by each
indicator is as follows:
OUT
Ind'~to!
"Format
np{M
,; i .i',
."iii . · A , m~ .
NTSC
NTSC
PAL PAL
31.5k VGA640x480
37k
VESA
BOO x 600
48k VESA 1024 x 768
64k VESA 1280 x 1024
1080i HDTV 1920 x 1080
For specifications of each format, see "Preset signals" on
page 49.
GEN·LOCK indicator
When the output signal format is PAL or NTSC and GEN
LOCK
is
set to ON on the menu screen, the GEN-LOCK
indicator lights
Of
flashes.