Servicing The Battery - Exmark LAZER Z Series Setup Instructions

D. Using one of the two wire ties included secure
the wire near where the seat hold up rod is
connected to the seat frame.
E. Using the second wire tie, secure the wire again to
approximately the middle of the seat hold up rod.
F. Connect the seat wire to the main wiring harness
lead. Slowly lower the seat checking that the wire
cannot contact any moving parts or pinch points.
Readjust wire ties if necessary.

Servicing the Battery

CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Note: The machine is shipped with a filled lead acid
battery.
1. Unhook seat latch and tilt seat up to gain access to
the battery.
Charging the battery may produce explosive
gasses. Battery gasses can explode causing
serious injury.
• Keep sparks, flames, or cigarettes away from
battery.
• Ventilate when charging or using battery in
an enclosed space.
• Make sure venting path of battery is always
open once battery is filled with acid.
2. Check the voltage of the battery with a digital
voltmeter. Locate the voltage reading of the battery
in the table below and charge the battery for the
recommended time interval to bring the charge up
to a full charge of 12.6 volts or greater.
Important: Make sure the negative battery
cables are disconnected and the battery charger
used for charging the battery has an output of
16 volts and 7 amps or less to avoid damaging
the battery (see chart for recommended charger
settings).
Warning
Danger
Percent
Voltage
Reading Charge
12.6 or 100%
greater
12.4 – 12.6 75–100%
12.2 – 12.4 50–75%
12.0–12.2 25–50%
11.7–12.0 0–25%
11.7 or less 0%
If the ignition is in the "ON" position there
is potential for sparks and engagement of
components. Sparks could cause an explosion
or moving parts could accidentally engage
causing personal injury
Be sure ignition switch is in the "OFF" position
before charging the battery.
3. Connect the negative battery cables.
Note: If the positive cable is also disconnected,
connect the positive (red) cable to the positive
battery terminal first, then the negative (black) cable
to the negative battery terminal. Slip insulator boot
over the positive terminal.
Note: If time does not permit charging the battery,
or if charging equipment is not available, connect
the negative battery cables and run the vehicle
continuously for 20 to 30 minutes to sufficiently
charge the battery.
Installing the Canister Air Cleaner
Kohler
1. Remove air cleaner (with bracket attached) from
seat frame. Keep air cleaner and mounting bracket
together.
2. Remove the top two valve cover mounting screws
from both left and right side engine valve covers.
Keep screws for re-attaching air cleaner.
3. Position the air cleaner assembly over the engine,
aligning air cleaner bracket holes with top holes in
4
Maximum Charging
Charger Interval
Settings
No Charging
16 volts/7
amps Required
30 Minutes
16 volts/7
amps
1 Hour
16 volts/7
amps
2 Hours
14.4 volts/4
amps
3 Hours
14.4 volts/4
amps
6 Hours or
14.4 volts/2
More
amps
Caution