New Holland LS35-16H Operator's Manual page 23

1
3
Figure 20
1. Oil dipstick
2. Metal end
Changing/Draining Oil
1. Start the engine and let it run five minutes. This warms
the oil so it drains better.
2. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil drains
completely. Then disengage the power take off (PTO),
set the parking brake, and turn the ignition key to off.
Remove the ignition key.
3. Open the hood.
4. Slide a piece of hose over oil drain to direct oil.
5. Place a pan below the oil drain. Open the drain by
turning counterclockwise, 1/8 turn and pull out
(Fig. 21).
6. When oil has drained completely, close the drain by
pushing in and turning clockwise, 1/8 turn.
Note: Dispose of the used oil at a certified recycling
center.
1
Figure 21
1. Oil drain
2
3. Filler tube
2
1216
2. Hose
7. Slowly pour approximately 80% of the specified
amount of oil into the filler tube (Fig. 20). Now check
the oil level; refer to Checking Oil Level, page 22.
Slowly add additional oil to bring to full mark on
dipstick.
Changing the Oil Filter
Replace the oil filter every 200 hours or every other oil
change.
Note: Change oil filter more frequently when operating
conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to
Changing/Draining Oil, page 23.
2. Remove the old filter and wipe the filter adapter
(Fig. 22) gasket surface.
3. Apply a thin coat of new oil to the rubber gasket on
the replacement filter (Fig. 22).
1
Figure 22
1. Oil filter
2. Gasket
4. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 turn (Fig. 22).
5. Fill the crankcase with the proper type of new oil;
refer to Changing/Draining Oil, page 23.
23
3
2
1256
3. Adapter