Driving Forward Or Backward; Stopping The Machine; Using The Attachment Lift Lever - New Holland LS35-16H Operator's Manual

interlock system is deactivated. The light goes out
whenever the power take off (PTO) is disengaged or the
engine is shut off.
PTO (Power Take Off)
The PTO (power take off) light will be on when the key is
in the run or lights positions and the PTO (power take
off) is engaged on. When this light is on it is a reminder;
the starter will not crank and turn off the PTO before
getting off.

Driving Forward or Backward

The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place the
throttle control in the fast position for best performance.
To go forward or backward, release the parking brake:
refer to Releasing the Parking Brake, page 13. Place your
foot on the traction control pedal and slowly press on the
top of the traction control pedal to move forward or on the
bottom of the traction control pedal to move backward
(Fig. 10). The farther you move the traction control pedal
in either direction, the faster the machine will move in
that direction.
Note: For reverse motion, with the PTO engaged, the
operating-in-reverse interlock must be deactivated by the
reverse interlock switch located on the seat bracket on the
right hand side just below the seat.
To slow down, release the pressure on the traction control
pedal.
Important
To avoid transmission damage, always
release the parking brake before moving the traction
control pedal.
Figure 10
1. Forward

Stopping the Machine

To stop the machine, release the traction control pedal,
disengage the power take off (PTO), and turn the ignition
key. Also set the parking brake if you leave the machine
unattended; refer to Setting the Parking Brake, page 13.
Remember to remove the ignition and reverse interlock
keys from the switches.
Caution
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition and reverse interlock
keys and set the parking brake when leaving the
machine unattended, even if just for a few
minutes.
Using the Attachment Lift
Lever
The attachment lift lever (Fig. 11) is used to raise and
lower various attachments.
Raising Attachments
1. Depress the brake pedal to stop the machine.
17
1
2
1210
2. Backward