Start-Up - Siemens SIMOVERT MASTERDRIVE SLE Operating Instructions Manual

SLE / SLE-DP – SIMOLINK Encoder
6

Start-Up

Siemens AG GWE-477 763 4070.76 J
SIMOVERT MASTERDRIVES
02.2001
The sequence of parameterizing steps for starting up the SIMOLINK
Encoder is as follows:
1. Set the SIMOLINK Encoder address on DIL switch S3
2. Set the SIMOLINK receive address on DIL switch S2
3. Set the SIMOLINK receive channel on DIL switches S1.1 - 1.3
4. Set the required number of pulses/revolution on DIL switches S1.7 - 1.8
5. Activate the SIMOLINK Encoder via DIL switch S1.5
6. Configure the SIMOLINK node which will transmit the setpoint
The SIMOLINK node which transmits the setpoint sets the position of
the zero pulse and starts the output of pulses via SIMOLINK if required.
When the parameters listed above have been set, both the SLE and the
SLE-DP encoder model is ready to operate. The PROFIBUS network
must also be set up and running before the PROFIBUS functionality
can be utilized. The remote parameter setting capability of the SLE-DP
via PROFIBUS will be available once the following settings have been
made (example given for SIMATIC S7):
1. Configure the SLE-DP as a PROFIBUS-DP slave in the SIMATIC
Manager
2. Program the SLE-DP address swap and the SLE-DP activation in
the control program
Via the PROFIBUS network the SLE-DP can be deactivated and the
receive address and receive channel altered; for this purpose, the
address and channel set via the DIL switches are OR'd bit-serially with
the value from the PROFIBUS telegram. The local and PROFIBUS
activation commands for the encoder have equal priority but DIL switch
S1.5 must be set for the PROFIBUS activation option. The SIMOLINK
node that transmits the setpoint and whose receive telegram is selected
in the SLE-DP also determines the position of the zero pulse and starts
pulse outputs via SIMOLINK if required.
Operating Instructions
Start-Up
6-1