How To Install The Wireless Remote Controller; Wireless Remote Controller Installation - Panasonic CZ-24KPU1U Series Installation Instructions Manual

5. HOW TO INSTALL THE WIRELESS REMOTE CONTROLLER

IMPORTANT
When using this air conditioner with the wireless remote controller it may sometimes be impossible to change
the operation modes while other indoor unit is running.
When this happens, a double beep tone sounds, the
(Standby lamp) blink alternately.
Operation is the same even during (AUTO mode) automatic cooling or heating.
A beep tone sounds 5 times and no changes can be made when any of the ON/OFF, MODE, Temperature setting
buttons were pressed while set under central control by the system controller.

5-1. Wireless Remote Controller Installation

The remote controller can be operated from either a non-fi xed position or a wall-mounted position.
To ensure that the air conditioner operates correctly, do not install the remote controller in the following places:
In direct sunlight.
Behind a curtain or other place where it is covered.
More than 26 ft. away from the air conditioner.
In the path of the air conditioner's airstream.
Where it may become extremely hot or cold.
Where it may be subject to electrical or magnetic interference.
(1) If Wall-mounted Fixed Position
Install the remote controller at a convenient
location on a nearby wall. However, before
attaching the remote controller mounting cradle,
check that the remote controller can operate from
the desired wall position. (Fig. 5-1)
How to Install Batteries
See Fig. 5-2.
(1) Press and slide the lid on the back of the remote
controller in the direction of the arrow.
(2) Install two AAA alkaline batteries. Make sure the
batteries point in the direction marked in the
battery compartment.
(3) Press the reset hole, then replace the lid. If you
press it, the current time, ON time, and OFF time
are all reset to 0:00.
Panasonic̲PAC-i̲IndoorUnit̲US-le40 40 Panasonic̲PAC-i̲IndoorUnit̲US-le40 40
(operation lamp) lights up, and the
Fasten the remote control
mount with screws.
Remote control mount
Fig. 5-1
Fig. 5-2
40
(Timer lamp) and
Fitting the remote
control in the mount.
2
Press
1
Put in
Reset hole
Cover
2011/11/02 15:17:32 2011/11/02 15:17:32