When Setting Indoor Unit Control Pcb Switch For Wall Mounted Indoor Unit - Panasonic CZ-24KPU1U Series Installation Instructions Manual

5-23. When Setting Indoor Unit Control PCB Switch for Wall Mounted Indoor Unit

When using both the wired and wireless remote controller, refer to the procedure below.
If this setting is not made correctly an alarm will occur. (The operation lamp on the display blinks.)
This setting is not necessary for the case of using wireless remote controller only.
The slide switch setting at the time of factory shipment for model K1 type is "B."
S-26PK1U6
When using wired remote controller as "sub", to set its
data to "sub" in remote controller setting mode.
When using wireless remote controller as "sub", set the
switch on the indoor unit control PCS to A.
Panasonic̲PAC-i̲IndoorUnit̲US-le56 56 Panasonic̲PAC-i̲IndoorUnit̲US-le56 56
When using
wireless
A remote
controller
Nos. 1, 2 OFF, No. 3 ON.
as "sub"
When using
wireless
remote
B
controller
as "main"
Nos. 1, 2, 3 all OFF
56
2011/11/02 15:17:39 2011/11/02 15:17:39