Reversing Camera - Skoda Superb Fitting Instructions Manual

Reversing camera
Hide thumbs Also See for Superb:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Reversing camera

The accessories are intended for professional fitting. ŠKODA AUTO recommends that they are
fitted by a contractual partner.
Use
The set is designed for Superb (3V) vehicles equipped with the MIB Amundsen, Bolero or
Columbus system.
The set 3V0 054 634 is designed for left-hand drive Superb (3V) vehicles.
The set 3V0 054 634A is designed for right-hand drive Superb (3V) vehicles.
The wiring harness for the boot lid (H, J) is not included in the set and must be ordered
from the ŠKODA Original Accessories range.
The wiring harness for the boot lid (H, fig. 1) (order number 3V0 054 634B) is designed for
left- and right-hand drive Superb (3V3) vehicles.
The wiring harness for the boot lid (J, fig. 1) (order number 3V0 054 634C) is designed for
left- and right-hand drive Superb Combi (3V5) vehicles.
Please note: The figures in the instructions provide general fitting
information. The instructions describe and use figures to explain how
to fit the reversing camera to the ŠKODA Superb (3V3). Other than
the differences illustrated in the figure by index B, the procedure for
fitting the reversing camera to the Superb Combi (3V5) is identical.
Set component index (fig. 1)
Component
Complete wiring harness
Recessed handle with reversing camera
3-pin protection connector (sleeve connector)
Cable tie
Foam-rubber piece
Self-adhesive foam-rubber tape
7.5 A MINI fuse
Fitting instructions
Special tools
Cutter set
Cable puller
Important fitting information
The utmost care must be taken to avoid damaging the wiring harness and the existing
electrical wiring in the boot lid when pulling through a section of the wiring harness (H, J)
from the recessed handle with the reversing camera (B) in the boot lid. This procedure must
be carried out in accordance with the workshop's practices.
Fitting procedure
The vehicle battery should be disconnected during fitting.
The individual components must be removed and refitted in accordance with the instructions
in the ŠKODA Repair Manual.
Quantity
Item
1
A
1
B
1
C
40
D
1
E
2
F
1
G
1
EN
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

3v0 054 6343v0 054 634a

Table of Contents