3Com 3CCFE575CT User Manual page 16

Setup Procedure
3Com 10/100 LAN CardBus PC Card User Guide
Setup Procedure
Setup Procedure
1. Install the PC Card as described in "Installing the PC Card".
2. Turn the notebook on.
Windows 98 automatically detects the PC Card, displays a New Hardware Found dialog box, and
looks for information about the PC Card.
When Windows is ready to configure the new hardware, Windows 98 opens the Add New
Hardware Wizard. The dialog box states that Windows will search for new drivers for the PCI
Ethernet Controller.
3. Click Next.
4. Select Search for the best driver for your device and click Next.
5. Select Floppy Drives, insert the LAN Installation Disk, and click Next.
After finding the files on the disk, Windows displays the prompt: Windows driver file for the
device:FE575C-3Com 10/100 LAN CardBus-Fast Ethernet.
6. Click Next to copy the required files.
The Add New Hardware Wizard window states that Windows has finished installing the driver.
7. If prompted, insert the Windows 98 CD. You can specify a location on your hard disk where the
Windows 98 files reside. Typically, this location is C:\WINDOWS\OPTIONS\CABS. Click OK to
copy the files needed for the Ethernet interface.
Please wait while Windows checks your current network configuration. The required time depends
on your settings for network software components.
A dialog box appears stating that Windows has finished installing the software that your new
hardware device requires.
8. Click Finish.
9. When Windows 98 prompts whether to reboot the computer, remove the LAN Installation Disk
from the floppy drive and click Yes.
file:///C|/aaafiles/Garfield 26/L10N/User Guide/Source/Final/New Folder/3C575-8.htm [10/26/1999 8:55:12 AM]
Contents | Support | Knowledge Base | FAQ | Software | FTP