TP-Link TD-W8968 User Manual page 39

 Internal Port End:
it blank.
 Server IP Address:
 WAN Interface:
Add: Click Add to add a new entry.

Remove: Select the check box in the table, click Remove, and then the corresponding

entry will be deleted in the table.
To add a virtual server entry:
1. Click Add on the preceding screen, and then you will see the new Virtual Server in the next
screen as shown below.
2. Select the Interface which you want to use from the drop-down list.
3. Select the service which you want to use from the drop-down list. If the list does not have
the service you need, type the name of the custom service in the text box.
4. Type the IP Address of the computer in the
5. Enter the External Port Start, External Port End, Internal Port Start and Internal Port End in
the table, and then select the protocol used for this Virtual Server, TCP,
6. Click Save/Apply
Virtual Servers Setup screen.

Note:
If you select the service from the drop-down list, the External Port Start, External Port End,
Internal Port Start, Internal Port End and the Protocol will be added in the table automatically.
You only need to enter the Server IP Address for the Virtual Server.
4.4.6.2 Port Triggering
Go to Advanced Setup
The end number of Internal Ports. You can type a service port or leave
The IP Address of the PC providing the service application.
The WAN Service Interface providing the service application.
to enable virtual server and then you will see your setting as shown on
→ NAT → Port Triggering, you can set Port Triggering on the screen.
Server IP Address text box.
35
TD-W8968 User Guide
UDP or TCP/UDP.