TP-Link TD-W8968 User Manual page 30

4.4.2.4 ATM-PPPoA
If your ISP provides a
below to add a WAN service over a selected ATM interface:
1. Add a new ATM interface and select
Interface).
2. Click Add in the WAN Port Information Table and the next configuration is similar to PPPoE,
(see section 4.4.2.1
PPPoE Service Name
4.4.2.5 ATM-IPoA
If your ISP provides an
below to add a WAN service over a selected ATM interface.
Add a new ATM interface and select
1.
Interface).
Click Add in the WAN Port Information Table and the next configuration is similar to
2.
(see section 4.4.2.2
Static IP Address, and the

Note:
ETH and ATM service can not coexist. If the ATM Interface had configured, you cannot
configure any other WAN service over the ETH Interface until the ATM Interface is deleted.
4.4.2.6 ETH-PPPoE
If your ISP provides a
following configuration is similar to
ATM-EoA-PPPoE).
4.4.2.7 ETH-IPoE
If your ISP provides an
next configuration is similar to
PPPoA connection, you need to use an ATM Interface. Follow the steps
ATM-EoA-PPPoE). The difference is that you don't need to set the
and Bridge PPPoE Frames Between WAN and Local
IPoA connection, you need to use an ATM Interface. Follow the steps
ATM-EoA-IPoE). The difference is that you have to manually set the
Static IP Address for DNS
PPPoE connection, click
PPPoE
IPoE connection, click
IPoE over ATM interface (see section
PPPoA option for DSL Link Type (see
IPoA option for DSL Link Type (see
Server.
Add in the WAN Port Information Table and the
over ATM interface (see section
Add in the WAN Port Information Table and the
26
TD-W8968 User Guide
4.4.1.1 ATM
Ports.
4.4.1.1 ATM
4.4.2.1
4.4.2.2 ATM-EoA-IPoE).
IPoE