Cleaning Detergent Siphoning Tube - Briggs & Stratton Speed Clean Operator's Manual

Cteaning Detergent Siphoning Tube
if you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine.
1. Place detergent siphoning tube in a bucket furl of clean
water.
2. Remove high pressure spray tip from nozzle extension.
3. Select and install black detergent spray tip following
instructions How to Use Spray Tips.
4. Flush for 1-2 minutes.
5. Shut off engine following instructions How to Stop
Pressure Was,_erandturn off water supply.
6. ALWAYS point gun in a safe direction, press red button
and squeeze spray gun trigger to releaseretained high
water pressure.
_l_ WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
o Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
o ALWAYS pointspraygun in safedirection,pressredbutton
andsqueeze sprayguntriggerto release highpressure, e very
time youstop engine.
Autematic Cool Dewn System (Thermal Relief)
if you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reachtemperatures above
125°F. The system engagesto cool the pump by discharging
the warm water ente the greundo
16 BRIGGSandSTRATTON.CONI