Pressure Washer Rinsing; Cleaning Detergent Siphoning Tube; Automatic Cool Down System - Briggs & Stratton BRUTE Operator's Manual

Pressure Washer Rinsing
For Rinsing:
1, Remove black detergent spray tip from nozzle
extension.
2, Select and install desired high pressure spray tip
following instructions Now to Use Spray Tips,
3, Keep the spray gun a safe distance from the area you
plan to spray.
WARNING Kickback from spray gun could cause you
to fall resulting in death or serious injury.
* Operate pressure washer from a stable surface.
* Be extremely careful if you must use the pressure washer from
a ladder, scaffolding, or any other similar location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
4. Apply a high pressure spray to a small area, then check
the surface for damage, if no damage is found, it is
okay to continue cleaning.
5. Start at the top of the area to be rinsed, working down
with same overlapping strokes as you used for washing
and applying detergent.
Cleaning Detergent Siphening Tube
if you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine.
1. Place detergent siphoning tube in a bucket full of clean
water.
2. Remove high pressure spray tip from nozzle extension.
3. Select and install black detergent spray tip following
instructions How to Use Spray Tips.
4. Flush for 1o2 minutes.
5. Shut off engine following instructions How to Stop
Pressure VVasherandturn off water supply.
6. ALWAYS point gun in a safe direction and press red
button and squeezespray gun trigger to release
retained high water pressure.
A WARNIN6 The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
o ALWAYS pointspraygun in safedirection,pressredbutton
andsqueeze sprayguntriggerto release highpressure, e very
time youstop engine,
Autemaiic Ceei Dewn System (Thermal Relief}
if you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reachtemperatures above
125°F. The system engagesto cool the pump by discharging
the warm water onto the ground.