Installing The Blower - Toro Z MASTER 79402 Operator's Manual

Installation
15. Slide new long spindle up from the bottom into
housing. Install the new double pulley with the
larger diameter pulley on bottom and secure with
existing washer and nut.(Fig. 8).
16. Torque the nut to 80–100 ft-lbs. (108–136 N m).
17. Transfer grease fitting and mower blade to long
spindle.
1
2
3
4
Figure 8
1. Nut (reuse)
2. Washer (reuse)
18. Inflate the tractor front tires to 12 psi (83 kPa),
and the rear tires to 10 psi (69 kPa).
8
3. New Dual Pulley
4. Spindle-long

Installing the Blower

1. Fasten the spring clip to the deck using a
3/8"-16 x 3/4" (19 mm) bolt, with head below
housing, and secure with locknut (Fig. 9).
2. Remove the existing hardware from spindle
mounting hole, then fasten the belt shield
bracket to the spindle hole using a
3/8"-16 x 1-1/4" (32mm) bolt, washer under the
bracket, and locknut (Fig. 9).
1
4
Figure 9
1. Belt Shield Bracket
2. Washer (under bracket)
3. 3/8"-16 x 1-1/4" (32 mm)
Bolt and Locknut
3
2
5
4. Spring Clip
5. 3/8"-16 x 3/4" (19 mm)
Bolt and Locknut