Installing The Hood Assembly And Bags - Toro TURBO FORCE Operator's Manual

Tightening all the Mounting Bolts
The following steps are the correct sequence to tighten the
side brackets and the bagger mounting bracket.
All mounting bolts need to be torqued to 35 ft–lb
(48 NV m).
1. Tighten the bagger mounting bracket to the rear frame
first (Fig. 12).
2. Tighten the bagger mounting bracket to the side
brackets (Fig. 12).
3. Tighten the side brackets to the side of the mower
(Fig. 11).
4. Install the drive wheels and torque to 95 ft-lb
(128 N M).
5. Lower the machine onto the drive wheels.
Step
8
Parts needed for this step:
1 Hood assembly
2 Bags
2 Clevis pins
2 Hairpin cotter pins
Installing the Hood Assembly
and Bags
Warning
Components around engine will be hot if the
machine has been running. Touching hot
components can cause burns.
Do not touch engine components when hot.
Allow engine to cool before performing
maintenance.
1. Install the hood assembly onto the bagger mounting
bracket (Fig. 13).
2
Figure 13
1. Hood assembly
2. Install the 2 clevis pins into the hood assembly and
bagger mounting bracket. Secure it with 2 hairpin
cotter pins (Fig. 14).
3
4
Figure 14
1. Hood assembly
2. Bagger mounting bracket
12
1
m–6758
2. Bagger mounting bracket
1
3
4
m–6759
3. Hairpin cotter pin
4. Clevis pin