Installing The Weights - Toro TURBO FORCE Operator's Manual

Step
13
Parts needed for this step:
2 Caster weights
2 Top weights
2 U–bolts
4 Nuts, 1/2 inch
2 Plates
4 Lock washers, 1/2 inch
2 Bolts, 1/2 x 3 inch

Installing the Weights

To comply with ANSI/OPEI B71.4–1999 Standard,
weights must be added to the machine.
Installing the Caster Weights
Caution
The bagger adds a lot of weight to the rear of the
machine and may cause an unstable condition
which could result in a loss of control.
Install the front caster weights and top weights.
1. Place a caster weight on the front caster and install the
U–bolt through the caster weight (Fig. 27).
2. Install the plate, the nuts (1/2 inch) and the lock
washer (1/2 inch) under the frame and caster weight
(Fig. 27).
3. Repeat for the opposite side.
Figure 27
1. Front caster weight
2. U–bolt
3. Plate
Installing the Extra Top Weight
1. Install the top weight on top of the caster weight with
a bolt (1/2 x 3 inch) (Fig. 28).
Figure 28
1. Top weight
2. Bolt
18
2
1
3 1
6
4
m–5882
4. Nut
5. Front caster
6. Lock washer
2
1
3
4
3. Front caster weight
4. Front caster wheel
5
m–6756