Main Features; Preliminary Process - NDS SMARTCHARGER SCS2 User Manual

3. main features

Plug and play.
•
OPTICHARGE the new firmware algorithm to check
•
the battery status and optimize the charge.
Specific Charging curve Ideal for every battery
•
technology, lithium batteries included (SCS4, SCS8).
Up to 9 charging steps (SCS4, SCS8).
•
IP65 protection.
•

4.Preliminary process

1. Remove battery from vehicle (if necessary).
2. Clean the terminals.
3. In case of lead acid Wet battery Add distilled water
in each cell until battery acid reaches level specified
by battery manufacturer. Do not overfill!
4. Before to start, always remove grounded connection
from battery and Make sure all the appliances in the
vehicle are off.
5. Be sure that the area around battery is well
ventilated while battery is charging.
CAUTION
To charge an engine battery
directly inside the vehicle
connect the negative clamp
to the vehicle chassis (usually
connected to the battery
n egative pole), th en th e
positive clamp to the battery
positive pole.
NEGATIVE
CLAMP ON
THE CHASSIS
-
4
POSITIVE
CLAMP ON THE
BATTERY POLE
+