Download
Share
Print this page
Toro 2226 Installation Instructions
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Drill
  5. 2226
  6. Installation instructions
Toro 2226 Installation Instructions

Toro 2226 Installation Instructions

Dirt and rock stakes directional drill
Hide thumbs Also See for 2226:
1
2
3
4

Advertisement

Quick Links

Download this manual
Dirt and Rock Stakes
2226 Directional Drill
Model No. 23840
Model No. 23840E
Model No. 23934
Model No. 23934E
This product contains a chemical or chemicals known to the State of California
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Dirt stakes
Stake pin
O-ring
Rock stakes
Stake guide
Spacer Plate
Bolts
Nuts
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
to cause cancer, birth defects, or reproductive harm.
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
2
2
Install the dirt stakes.
2
2
2
2
Install the rock stakes.
8
8
Form No. 3418-572 Rev A
Installation Instructions
Use
Original Instructions (EN)
All Rights Reserved *3418-572* A
Printed in the USA.

Advertisement

loading
Need help?

Need help?

Do you have a question about the 2226 and is the answer not in the manual?

Questions and answers

Related Manuals for Toro 2226

Summary of Contents for Toro 2226

  • Page 1 Form No. 3418-572 Rev A Dirt and Rock Stakes 2226 Directional Drill Model No. 23840 Model No. 23840E Model No. 23934 Model No. 23934E Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
  • Page 2 Installing the Dirt Stakes Installing the Dirt Stakes Install the new stakes by aligning the hole in the stake with the hole in the motor coupler and secure it with Preparing the Machine and the O-rings and pins included in this kit (Figure Removing the Current Stakes Note:...
  • Page 3 Installing the Rock Stakes Preparing the Machine and Removing the Current Stakes Note: Having 2 people or a lifting mechanism makes it easier to install the stakes. Move the machine to a level surface. Position the thrust frame 25.4 cm (12 inches) off the ground, with the stakes in the up position.
  • Page 4 Secure the stake guide and spacer to the platform using 8 bolts and 8 nuts. Torque the bolt to 37 to 45 N∙m (27 to 33 ft-lb). g231545 Figure 4 Align the hole in the stake with the hole in the motor and secure it with the pin and O-ring (Figure 4 Figure...

This manual is also suitable for:

2384023840e2393423934e