Table of Contents
Advertisement
Associating the Handheld
Transmitter with the Base Unit
If the handheld transmitter ever stops communicating with
the base unit, or if you replace it with a new transmitter, you
need to associate the transmitter to the base unit as follows:
1. Ensure that the machine is turned off.
2. Ensure that the handheld transmitter is not active (i.e.,
no lights are on).
3. Stand near the rear control panel of the machine.
4. Simultaneously press and hold the On and Off buttons.
All of the lights will illuminate.
5. Continue holding the buttons until the TX light begins
flashing.
6. Continue holding the On and Off buttons and turn on
the machine to power the base unit.
The base unit and handheld establish a communication
link while you hold the button. Once the process is
complete, all of the lights will flash.
7. Release the buttons.
Disassociating all Handheld
Transmitters from the Base
Unit
Important: Completing this procedure will disassociate
all transmitters from the base unit, which will need to be
associated again before they will function.
1. Ensure that the machine is turned off.
2. Ensure that the handheld transmitter is not active (i.e.,
no lights are on).
3. Stand near the rear control panel of the machine.
4. Simultaneously press and hold the On and Off buttons.
The Green light illuminates.
5. Continue holding the buttons until the Yellow light
begins flashing, then release the buttons.
The Red light begins flashing allowing you 2 seconds
to press the next button.
6. Press and hold the Off button
The Red light turns off and the Green and Yellow
lights illuminate.
Important: If you do not press this button within
2 seconds, you will have to start this procedure
over again.
7. Continue holding the Off button and turn on the
machine to power the base unit.
The base unit and handheld establish a communication
link while you hold the button. Once the process is
complete, the Yellow light turns off, the Red light
begins flashing, and the Green light illuminates. All
lights remain as mentioned until you release the button.
8. Release the Off button.
The Red light turns off and the Green light flashes for
a few seconds.
5
Advertisement
Table of Contents
