Transporting The Machine - Toro Sand Pro 2040Z Operator's Manual

Figure 28
Left bypass-valve lever
1
Figure 29
Right bypass-valve lever
Figure 30
1. Inward to push or tow the
machine
4. When you are finished pushing or towing the machine,
rotate the bypass-valve levers so that they point toward
the front of the machine, to allow the machine to drive
(Figure 30).
1
G023553
G023554
1
2
G023555
2. Forward to drive the
machine

Transporting the Machine

Use a heavy-duty trailer or truck to transport the machine.
Ensure that the transport vehicle (trailer or truck) has all
the necessary brakes, lighting, and marking as required by
law. Carefully read and understand all the safety instructions.
Knowing this information could help you, your family, pets,
or bystanders avoid injury.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous and can
lead to accidents causing personal injury.
Do not drive the machine on a public street or
roadway.
Use extreme caution when loading the machine onto the
transport vehicle. Use a full-width ramp that is wide enough
to extend beyond the rear tires, instead of individual ramps
for each side of the machine. The attachment serves as a stop
for tipping backward. Using a full-width ramp provides a
larger surface for the attachment to contact if the machine
starts to tip backward.
Ensure that the ramp is long enough so that the angle does
not exceed 13 degrees. A steeper angle may cause machine
components to get caught as the machine moves from the
ramp to the transport vehicle. Steeper angles may also cause
the machine to tip backward. If loading on or near a slope,
position the transport vehicle so that it is on the down side
of the slope and the ramp extends up the slope; this will
minimize the ramp angle. The transport vehicle should be as
level as possible.
30