Advantech PCA-6153 Manual page 54

1. Apply power to the PCA-6153 with a color TFT display
attached. This is the default setting for the PCA-6153. Ensure
that the AWDFLASH.EXE and *.BIN files are located in the
working drive.
NOTE:
2. At the prompt, type AWDFLASH.EXE and press <Enter>. The
VGA configuration program will then display the following:
File Name to Program
Error Message:
3. At the prompt, type in the BIN file which supports your
display. When you are sure that you have entered the file name
correctly press <Enter>. The screen will ask "Do you want to
save?" If you wish to continue press Y. If you change your
mind or have made a mistake press N to abort and end the
setup procedure.
4. If you decide to continue, the screen will issue a prompt which
will then ask "Are you sure to program (Y/N)?" If you wish to
continue, press Y. Press N to exit the program.
The new VGA configuration will then write to the ROM BIOS
chip. This configuration will remain the same until you run the
AWDFLASH.EXE program and change the settings.
46 PCA-6153 User's Manual
Ensure that you do not run AWDFLASH.EXE
while your system is operating in EMM386 mode.
FLASH MEMORY WRITER v.5.2.B
Copyright (c) 1993 Award Software, Inc.
For SiS-5571-2A5IHAK9C
Flash Type-
VGA Setup screen
03/28/97