Table of Contents
Advertisement
5
Functions
5.1
Humidity
By pressing the MODE key once, you can switch between the display of the temperature of the
external sensor and of the humidity inside.
5.2
Temperature unit
Press the temperature unit key to change the unit in which the temperature is displayed.
5.3
Min/Max function
•
Press the MIN key to display the lowest measured temperature.
•
Press the MAX key to display the highest measured temperature.
•
Press and hold the MIN key for 3 seconds to reset the lowest measured temperature.
•
Press and hold the MAX key for 3 seconds to reset the highest measured temperature.
5.4
Wake-up function
To set an alarm time, press and hold the MODE key until you hear a beep tone. Press the MODE
key until a bell icon appears in the display and the hour flashes.
•
Use the UP and DOWN keys to set the hour.
•
Press the MODE key again to set the minutes with the UP and DOWN keys.
You can exit setting mode with the temperature unit key.
The alarm time can also be activated/deactivated with the temperature unit key.
5.5
Comfort level
From the measured parameters, the hygrometer determines a comfort level which gives
information about the comfort in a flat or office. This is indicated by a smiley on the left edge of
the display.
6
Battery replacement
The top left of the display shows the battery level. It is necessary to change the batteries when
no bar is shown in the battery display. To do so, open the battery compartment and insert new
batteries, observing the correct polarity.
© PCE Instruments
4
Advertisement
Table of Contents
