Safety notes Please read this manual carefully and completely before you use the device for the first time. The device may only be used by qualified personnel and repaired by PCE Instruments personnel. Damage or injuries caused by non-observance of the manual are excluded from our liability and not covered by our warranty.
Introduction This instrument is a digital thermometer for use with platinum-type temperature sensor. Temperature indication follows IEC751 temperature table for PT-type sensor. Specifications Numerical Display 4 digital liquid crystal display -100 °C … 300 °C; -148 °F … 572 °F Measurement Range Resolution 0.1 °C;...
Symbol Definition and Button Location : This indicates that the minus temperature is sensed. °C °F : Centigrade and Fahrenheit indication. Pt xxx : Platinum Type Indication 4.1.1.1.1.1.1 HOLD : This indicates that the display data is being hold. MAX : The Maximum value is now being displayed MIN : The Minimum value is now being displayed AVG : The Average value is now being displayed.
Connection of the temperature probe For measurement, plug the temperature probe into the input connectors. Selecting the Temperature Scale When the meter was first power on, the default scale setting is set at Celsius (°C) scale. The user may change it to Fahrenheit (°F) by pressing “ °C/°F ” button and vice versa to Celsius. Data-Hold Operation The user may hold the present reading and keep it on the display by pressing the “HOLD”...
MAX/MIN/AVG Operation When you press the “MAX MIN” button the meter will enter the MAX/MIN/AVG mode. Under this mode the maximum value, minimum value and average value of latest 8 data is kept in the memory simultaneously and updated with every new data. When the MAX symbol is display, the Maximum is shown on the display.
Press “REL” button to confirm present calibration value. Press “°C/°F” button to confirm selection. Recall Default factory setting value Press and hold “Power” + “Light” buttons for 2 seconds to enter setup mode. Press “REL” button to enter calibration mode. Enter Pt selection first.
Maintenance 18.1 Replacing the Batteries (1) Remove back cover screw to remove cover. Verify polarity and install new LR03(AAA size) alkaline batteries. (2) Fit cover properly and tighten screw. The unit’s back cover is fitted with rubber rings. After replacing the battery, check that the rubber rings are properly seated before reinstalling the back cover.
Temperature Probe 19.1 Piercing type temperature probe 19.2 Piercing type temperature probe Specification Sensor Type Platinum resistance thermometer sensor Pt 100(4 wires) Accuracy IEC751, class A 0.15C0.002t (t: measurement temperature) Measurement Range -100 to 400C Approx. 3.2mm(0.125”) Temperature Sensor Dimensions Approx.
Warranty You can read our warranty terms in our General Business Terms which you can find here: https://www.pce-instruments.com/english/terms. Disposal For the disposal of batteries in the EU, the 2006/66/EC directive of the European Parliament applies. Due to the contained pollutants, batteries must not be disposed of as household waste. They must be given to collection points designed for that purpose.
Page 18
PCE Instruments contact information Germany France Spain PCE Deutschland GmbH PCE Instruments France EURL PCE Ibérica S.L. Im Langel 4 23, rue de Strasbourg Calle Mayor, 53 D-59872 Meschede 67250 SOULTZ-SOUS-FORETS 02500 Tobarra (Albacete) Deutschland France España Tel.: +49 (0) 2903 976 99 0 Téléphone: +33 (0) 972 3537 17 Tel.