Replacing The Light Bulb; Tidalfit Cabinet Care - TidalFit EP-12 Owner's Manual

MAINTAINING YOUR TIDALFIT

REPLACING THE LIGHT BULB

1 ) Turn off the power at the main electrical service panel.
2) Remove front access panel.
3) Locate and remove the reflector by turning it counterclockwise until
free from wall fitting.
4) Remove the bulb from the holder.
5) Replace with new bulb. Your dealer has these bulbs in stock.
6) Replace the reflector by screwing it clockwise back onto the wall fit-
ting.
7) Replace the front panel.
8) Turn power on at the main electrical service panel.
NOTE: The pool light bulb is not covered under warranty.

TIDALFIT CABINET CARE

Your pool comes standard with a KingWood, or faux wood, cabinet. This
cabinet requires no maintenance. You may wish to clean the cabinet with
mild soap and water from time to time. If you elected to purchase your
TidalFit with a wood cabinet, this cabinet is stained and sealed with an
oil based acrylic stain. The stain is formulated especially for pool cabinet
and deck applications and is resistant to ultraviolet light damage caused
by sun rays. It is also resistant to fungus and insect damage. Your dealer
carries this type of stain for your convenience, so call your dealer when
you're ready to re-stain your cabinet. You should re-stain your wood
cabinet at least once a year, or more frequently depending on your envi-
ronmental conditions.
1) Gently wash the cabinet with mild soap and water and allow to dry
completely.
2) Moisten a rag with the stain you have purchased from your dealer.
3) Apply the stain on the entire cabinet surface, wiping off any excess
stain as you are applying.
4) Allow stain to dry for a minimum of 24 hours before getting the cabinet
wet.
59