Ready Mode; Rest Mode - TidalFit EP-12 Owner's Manual

TOPSIDE CONTROL INSTRUCTIONS

READY MODE

In ready mode the heater will maintain the set temperature. If your Tidal-
Fit spa is not programmed for 24 hours Filter it will turn on the circulation
pump every half an hour to test the water temperature. If the water temper-
ature is one degree below the set point the circulation pump will continue
to run to bring the water temperature to the set point temperature.
If the water temperature is at the set point temperature the circulation
pump will turn off after 5 minutes. If your filtration cycle is set for 24 hours,
the circulation pump will continue to run.

REST MODE

Will only allow the spa to heat during a filtration cycle, if the spa is not in
a filtration cycle, you can press the pump 1 button to activate the heater.
The spa will go into Ready mode for 1 hour and then go back to rest mode.
Select Button: When the heat mode is highlighted in the Settings
Menu pressing the Select Button will change from Ready to
Rest or Rest to Ready.
Left Button: Press the left button to highlight the Back Icon.
Select Button: Press the select button to return to the main Menu.
OR
Down Button: Press the down button to go to Time of Day.
Settings
Temp Range
Heat Mode
Time of Day
Filter Cycles
Light Cycle
Invert Panel
Lock
32
High
Rest
Normal