Verifying Water Circulation; Testing The Gfci Breaker - TidalFit EP-12 Owner's Manual

TIDALFIT START-UP

VERIFYING WATER CIRCULATION

1) Open all the jets.
2) Press the Pump 1 key to turn the pumps on or off.
3) Make sure each seat has water flow.
NOTE: On certain pools there is a diverter valve. Verify where the
diverter valve is located.

TESTING THE GFCI BREAKER

NOTE: The electrical service panel for your pool should be equipped
with a GFCI breaker. To avoid the risk of electrical shock, perform the
following safety test before each use of your pool.
1) Make sure the power is turned on at the electrical service panel.
2) Turn on the GFCI breaker. If the breaker stays on, it is functioning prop-
erly.
NOTE: The spa system will automatically trip the GFCI 24 hours after
power up. This is a safety feature and can not be disabled.
DANGER: RISK OF ELECTRICAL SHOCK
I f the GFCI breaker fails to operate as described, there is a possibility of
an electrical shock if the TidalFit is used. Shut off the power at the main
electrical service panel until the source of the problem has been identified
and corrected by a licensed electrician or qualified pool technician.
NOTE: When power is turned on, your pool is automatically pro-
grammed to start circulating water through the circulation pump.
Each pump and blower will come on consecutively for approximately
1 minute to automatically purge the system. Adjust your temperature
by pressing the up button on your touch pad until the desired tem-
perature is displayed. This setting will allow your pool to heat to the
set temperature.
CAUTION: If water is not noticeably coming from your pool jets during the
automatic purge, turn on the high speed pump. If water is still not coming
from the jets, the pump needs to be manually primed, following the steps
below.
24