Removing, Installing And Cleaning Filters; Winterizing Your Tidalfit - TidalFit EP-12 Owner's Manual

MAINTAINING YOUR TIDALFIT

REMOVING, INSTALLING AND CLEANING FILTERS

These are the steps needed to successfully replace your filters You should
replace your disposable pool filters and clean your non-disposable filters
every four months.
1) Turn off all power to your pool and remove the filter lid by lifting it out
towards you.
2) Turn the filter counterclockwise and remove it from the filter well.
3) Dispose of the used filter.
4) To replace, set screen back into its place turn clockwise to fasten. DO
NOT over-tighten.
5) Place the new filter into position and turn clockwise to fasten. DO NOT
over-tighten.
6) Follow the directions 1) and 2) for the pleated filter cartridge. You then
rinse the filter with a garden hose and soak the filter in a mixture of one
pint of filter cleaner with 2.5 gallons of water for at least 12 hours. The
filter must be completely submerged. You then follow the directions 4) and
5) to replace the filter
WARNING: Power to your pool must be turned off prior to remov-
ing your filters. The suction at the filter is extremely strong and can
cause injury if there is no filter. NEVER run your pool without the
filters properly installed. Injury to person and damage to the equip-
ment can occur. Any damage to equipment due to this circumstance
will not be covered under warranty.

WINTERIZING YOUR TIDALFIT

I t is not recommended that you drain your pool completely during freezing
conditions. We recommend that you leave your pool full of water with the
power on to keep the tub from freezing. If you decide to drain your pool
during freezing conditions, contact your dealer for help. Contact your
dealer before refilling a drained pool in freezing temperature.
WARNING: Damage to your pool caused by freezing is NOT covered
under warranty. Please contact your local Artesian dealer to assist you in
winterizing your pool.
58