Table of Contents
Advertisement
DT9100 B
Wiring plan, connecting
the digital outputs
(see also "Application
example")
Be careful with the polarity
of the cables.
20180905-V1
5.3. Connecting the digital outputs
A DT9100 B digital output is an output for the direct driving
of another clock synchronising input or a NAMUR input.
You may connect an instrument to the output if its input is
in conformity with the following output parameters:
Uo < 10 V, Io < 200 mA, Po < 0.5 W.
The following figure shows the connection:
1. Push the cable end into the terminal assembly as far as
possible. By pushing the wire in, the self-closing connection
is being established.
2. Check it by pulling it outwards slightly.
21
Advertisement
Table of Contents
