Tests (10. Menu Item) - Datcon DT9100 B Operating Instructions Manual

Function
Sequence of operations 1. Enter the menu by typing in either the user code or the
42

7.12. Tests (10. menu item)

Checking of the display and the limit values of outputs.
supervisor code.
The way the code should be typed in is described in
Chapter 7.1. Type in the code (password). You will see

this: .
2. Keep stepping by pressing the ▲ button until the menu

item appears.
3. Enter the menu item by pressing the ENTER button.
4. You will see this
Display test). The mnemonic
5. If you want to test the display, press the ENTER button.
In this case all the segments on the display get switched
on. By pressing the ▲ button several times you can select
from several test patterns by which you can decide whether
the display is good or not. You may exit from the display
test by pressing the MENU button. You will see this
again.
6. If you want to test the limit value of outputs, press the ▲
button to switch to the
mnemonic. (Its meaning: Output test).
7. Press the ENTER button.
8. You will see this:
the status of the digital outputs. In this present case both of
them are switched off. This is why the blinking sign is in the
middle position.
9. Pressing the ▲ button, you can switch the outputs on.

•
 = both are switched OFF.

•
 = 1. ON; 2. OFF.

•
 = 1. OFF; 2. ON.

•
 = both are switched ON.
Comment: the status you have selected here remains
unchanged as long as you exit the menu, and the
instrument starts measuring.
10. You can exit the output test by pressing the MENU
button. You will see the blinking

on the display. (Its meaning:

will be blinking.

mnemonic from the

. The blinking signs indicate

DT9100 B


mnemonic again.
20180905-V120180905