Vehicle Setup - GE MobileView 4 Installation Manual

36 MobileView 4
Installation Manual
The following features allow you to configure all remote settings:
•

Vehicle setup

• Camera setup
• Audio setup
• Alarm events
• I/O devices
• System
Note: This system configuration section provides limited detail required to accommodate initial DVR setup.
For greater detail, refer to the MobileView 4 Video Manager User Manual.
Vehicle setup
To use Vehicle setup, do the following:
1. Press the Vehicle setup button on the left side of the configuration screen
(Figure 32 on page 37) to configure your vehicle setup.
2. Enter your Depot ID (DVR number) and its corresponding vehicle ID.
3. Designate how your vehicle is tracked or monitored. If it is a fixed location, check
the Fixed location radio button and enter the location's coordinates. If using a
mobile recorder, check the Mobile recorder radio button.
4. Note the software version information.
5. Select the
J11.8, turns on when the archive partition is full. (See
page 22).
6. Select the
Camera status output, J11.8, turns on when the current time precedes recorded time
by more than 5-minutes. (See
7. Click Close.
on page 38
on page 46
on page 47
on page 50
on page 51
Display Disk Full as Fault
Display Future Recording Time Warning
check box. The Camera status output,
Status output connections
Status output connections
check box. The
on page 22).
on