20
MobileView 4
Installation Manual
Wiring
Wiring connections between the DVR and auxiliary devices are made to the DVR's back
box (Figure 15). Wires enter through the cable-entry hole.
Figure 15. DVR back box connections
Network
J14: Relays
J13: Analog/Digital inputs
Camera power connections
The J10 and J11 camera power terminal blocks provide power to the vehicle's cameras. To
wire the camera power connections, do the following:
1. Remove the camera power terminal block from the back box by loosening its
mounting screws and pulling it out of its socket.
2. Make connections as shown in Figure 16. To make connections, strip each wire
3/8 in. (10 mm), insert it into the appropriate slot, then tighten the terminal screw.
3. Reinstall the camera power terminal block.
Figure 16. Camera power terminal block connections
J11: Camera power channels 7 to 12
MUX
GPS
1
Composite
1
5V, 2 A fuse
BNC connections
J10: Camera power power
1
J11: Camera power
12V, 2 A fuse
1
J9: Audio
J1: Serial/LEDs
J10: Camera power channels 1 to 6
J12: Power
1
1
24V. 10 A fuse
COM3
1