Turning The Disklavier On - Yamaha disklavier IV / Pro Series Maintenance Handbook

5. MKIV/Pro installation manual

5 - 7. Turning the Disklavier on

This procedure is similar to turning on a desk
HINT!
top PC
1) Confirm that the power cable of the Power Supply
unit is connected to an AC wall outlet.
2) Press the [ON] side of the [POWER] switch on the
Monitor speakers.
Note:The Monitor speakers are supplied only with the Mark IV
Series.
3) Press the [ON] side of the [MAINS] switch on the
Power Supply unit.
4) Press the [ON] side of the [MAINS] switch on the
I/O Center.
on the Media Center starts flashing green.
Wait until on the Media Center stops flashing and
dimly lights green. After several minutes, go to step 5.
5) Press . The Disklavier is turned on and the [Main]
screen appears.The touch screen changes as follows:
Note:This may take approximately two minutes.
Note:When turning the Disklavier back on after shutting down, be sure to wait 10 seconds before doing so.
Tip:Pressing on the Media Center also turns the Disklavier on. In such a case, be sure to press
turn on the Pocket Controller as well.
PRC100 wireless LAN Communication range
Around 30m (100 ft.) is the maximum range with no obstacles.
Please refer to 5-13-2. (Show wireless communication status)
MHB23 MKIV/PRO DIOV1.05, SCV.1.01 PAGE.11
to