Table of Contents
Advertisement
5. MKIV/Pro installation manual
5 - 12 - 3. PRC100 rebooting, resetting and pairing
Rebooting or resetting will be more effective
HINT!
countermeasure than Mark III systems
Rebooting the Pocket Controller
1) Tap on
on the task bar.
2) Tap on [Reboot]
on the menu that appears.
3) Tap on [Yes].The [Main] screen appears after approxi-
mately three minutes.
In case you change the PRC100 to a new one for some reason, you need to pair the new PRC100 and
Disklavier as follows:
Pairing the Pocket Controller and the Disklavier
For normal use, this setup has been done in the factory.
1) Make sure that other wireless equipment is turned off.
2) Tap on [Piano Assign] in the [PRC-100 Menu] screen.
3) Move the Pocket Controller close to the Disklavier,
and then tap on .
4) Tap on [OK] .
5) Tap on [OK] on the [Assigned successfully] screen.
The [PRC-100 Menu] screen resumes.
Note: Do NOT abort the procedure before step 4.
Otherwise you cannot control the Disklavier.
Resetting the Pocket Controller
When rebooting cannot be performed or the Pocket
Controller does not work correctly even after rebooting,
follow the procedure below.
1) Connect the AC adapter to the AC adaptor jack, and
then set the battery replacement switch to the
[REPLACE BATTERY] position.
2) Wait for five seconds, remove the battery compartment
lid, and then press the [RESET] button with the stylus pen.
3) Replace the battery compartment lid, and then set the
battery replacement switch back to the [NORMAL OPERA-
TION] position.
4) Press to turn the Pocket Controller on. The [Main] screen
appears after approximately two minutes.
MHB23 MKIV/PRO DIOV1.05, SCV.1.01 PAGE.18
Hide quick links:
Advertisement
Table of Contents
