Quick Reference Table - Supermicro H11DSi User Manual

H11DSi / H11DSi-NT User's Manual

Quick Reference Table

Jumper Description
UID SW Unit ID Switch (push-button toggle switch ON/OFF)
JI2C1 / JI2C2 PCI-E Slot SMB (System Management Bus) Enable/Disable
JBT1 CMOS Clear
JPG1 VGA Enable/Disable
JPL1 LAN Enable/Disable
JWD1 Watch Dog
LED Description
UID LED Unit ID LED
LED2 Onboard Overheat / Fan Failure
LED3 Onboard Power LED
LEDM1 BMC Heartbeat LED
Connector
JIPMB1
COM1
FANA, FANB, FAN1~FAN6
P2-SATA0, P2-SATA1
CPU1-SATA0-3, CPU2-SATA0-3
JF1
JL1
LAN1/LAN2
IPMI LAN
JPWR1
JPWR2/JPWR3
JSD1/JSD2
JMD1
JTPM1
USB0/1, USB4/5
USB2/3
P2-NVME0/1
JSTBY1
BT1
Status
Solid Blue: UID Switched to ON
Solid Red: System Overheat, Blinking Red: Fan Failure
Off: Sytem Off, Solid Green: System ON
Blinking Green: Normal
Description
System Management Bus Header
COM Port
4-pin System/CPU Fan Headers
SATA 3.0 Ports for SATA/DOM with integrated power
Connectors for SATA0~3, use iPass breaklout cable (4 ports each)
Front Control Panel Header 1
Chassis Intrusion Header
RJ45 LAN Port (H11DSi-NT supports 10Gb)
Gigabit LAN (RJ45) Port for IPMI
24-pin Main Power Connector
8-pin Auxilliary Power Connectors
SATA DOM (Device on Module) power connectors 1/2
M.2 Connector with integrated SATA/PCIe signals
Trusted Platform Module/Port 80 Connector
Back Panel USB Type A Ports for USB0/USB1 (2.0) and USB4/USB5 (3.0)
Front Panel USB Header for USB2/USB3 (2.0).
Processor 2 NVMe Ports 0/1 for NVMe Hard Disk Drives (H11DSi-NT only)
Stand-by Power Header
On-board CMOS Backup Battery
12
Default Setting
Off
Pins 2-3 (Disabled)
Open (Normal)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)