Toto EcoPower TEL3GSC Instruction Manual page 9

Loose spout
Check if the spout is loose.
If the spout is loose, tighten the hexagonal nut underneath the spout.
Flow rate
When the strainer or spout nozzle is clogged, the ow rate
will decrease.
Make sure to clean the strainer and the spout nozzle.
Pay special attention to the Eco power model, since low ow
rate may result in low power generation. (see page 5)
Cleaning the strainer
1. Close the stop valve.
2. Remove the strainer cover with the open-close
tool.
3. Pull out the strainer and clean it with a brush.
4. Put the strainer back in its place.
5. Reopen the stop valve fully.
Cleaning of the spout nozzle
1. Remove the spout nozzle with the supplied
open-close tool.
2. Clean the spout nozzle with a brush to
remove dirt from the screen.
3. Set the spout nozzle back in place.
Close
Open
Strainer
Open-close tool
Open
Brush
Strainer
Close
Open
Spout nozzle
Brush
Spout nozzle
Stop valve
Strainer cover
Open-close tool
8