Technics SH-8066 Operating Instructions Manual page 3

SUGGESTIONS FOR SAFETY
Before using this unit, be sure to read applicable items of the operating instructions and these safety suggestions carefully;
and afterwards keep them handy for future reference. Take special care to follow the warnings indicated on the unit itself as
well as in the operating instructions.
1.
2.
Avoid places where there is water or humidity.
Do not use this unit near a bathtub. washbasin . swimming
pool . or the l1ke. Damp basements should also be
avoided .
Don't allow water or any foreign object to get
inside this unit.
Don't place small metal objects or anything containi ng
liquid on or near the unit.
3.
Avoid placement of the unit where it will be
exposed to the direct rays of the sun, or where
ventilation is inadequate.
Don't place this unit in a bookcase or between cabinets ,
or wh ere curtains or furniture may obstruct the ventila-
tion holes.
4.
Place this unit away from heat-emitting appli-
ances.
Never place this unit near a radiator. heat register . stove,
or any other heat-emitting equipment (including ampli-
fiers) .
5.
Placement
Place the unit on a stable. vibration-free. level shelf or
stand.
6.
Use of a cart or stand
7.
8.
When deciding on a cart or stand, be sure to follow the
recommendations for this unit in the operating instruc-
tions.
Wall or ceiling installation
If the unit is to be mounted on a wall or ceiling , be sure to
do so only as recommended in the operating instruc-
tions.
Check the voltage rating of this unit before
connecting the unit to a power supply.
Be sure to connect the unit only t o the type of power
supply indicated in the operating instructions. or as
indicated on th e unit itself.
9.
Concerning the power outlet(s) of this unit
If this unit has a built-in electric power receptacle, be sure
to connect only equipment with a power rating not
exceeding that indicated by the receptacle of this unit.
(Only connect audio equipment to this outlet.)
10.
Care of the power cord and plug
Take care that the cord is not bent sharply (especially
near its connection to th e unit or near the plug). that
nothing is placed on it, and that it is not pinched or
crushed. Never take hold of the plug or cord if your hand
is wet, and always be sure to grasp the plug body when
connecting or disconnecting it.
11.
Outdoor antenna grounding
If an outside antenna is connected
to the receiver, be sure the antenna
system is grounded so as to provide
some protection against voltage
surges and built-up static charges.
Section
810
of the National Elec-
trical Code, ANSI /- NFPA No. 70
- 1981,
provides information with
respect to proper grounding of the
mast and supporting structure,
grounding of the lead-in wire to an
antenna discharge unit. size of
grounding conductors, location of
antenna-discharge unit, connec-
tion to grounding electrodes, and
requirements for the grounding
electrode. See the figure at right .
EXAMPLE OF ANTENNA
GROUNDING AS PER
NATIONAL
ELECTRICAL CODE
INSTRUCTIONS
:: Su1 table
~ Ground 1 ng
Eleclr ode
On ven
a· 1n1o
the Earth
(2 .44 Meters)
a ) Use No 10 AWG coppe r or No 8AWG alumtnum o r No. 17 AWG c opper-
clad steel or bronze wtre. or larger as ground wtres lor both mast and
antenna dtscharge ground w tre
b )Secu re lead - tn wtre from antenna to antenna dtscharge un tt and mast
ground wtre
to
house
wtth stand-off tnsulators .
spaced from 4 feet
( 1.22 meters) to 6 feet (1 .83 meters ) apart
c ) Moun
t antenna dtscharge
un1t
as closely as
poss tble to where
tead- m
e nters house
12.
Power lines
When installing an outdoor antenna, install it as far as
possible from power lines.
13.
If the unit will not be used for a long period of time:
Be sure to disconnect the power cord.
14.
Never attempt repairs yourself:
(a) If the power cord or plug is damaged.
(b) If a foreign object or liquid falls into the unit.
(c) If the unit is exposed to rain.
(d) If the unit does not function normally, or if operation
shows an unusual c hange.
(e) If the unit has been dropped and the cabinet or
chassis are damaged ... etc.
Unplug the power cord and co nsult with a qualified
technician (or the dealer from wh om the unit was
purchased or the nearest service center) .
15.
Repairs
- 3 -
Except for adjustments explained in the operating
instructions, do not attempt any repairs yourself. Be sure
to request service from a qualified technician (or your
dealer or nearest service center) .