Whirlpool ACE 010 Installation, Quick Start page 12

PROBLEM
N
O ESPRESSO COFFEE IS DELIVERED
T from
HE ESPRESSO COFFEE DRIPS
the edges of the filter holder
rather than the holes.
T
HE ESPRESSO COFFEE IS COLD
T
HE PUMP IS EXCESSIVELY NOISY
12
POSSIBLE CAUSE
No water in the tank
The holes in the fil-
ter holder spouts are
blocked.
The espresso boiler outlet
is blocked
The filter is blocked
The tank is incorrectly in-
serted
The filter holder is insert-
ed incorrectly
The espresso boiler gas-
ket has lost elasticity
The holes in the filter
holder spouts
The espresso OK indicator
light was not on when the
coffe switch was pressed
No preheating performed
The cups were not pre-
heated
The water tank is empty
The tank is incorrectly in-
serted.
SOLUTION
Fill the tank with water
Clean the spout holes.
Clean as described in the
chapter "Cleaning the
boiler outlet"
Clean as described in the
section "cleaning the filter
holder".
Insert tank correctly.
Attach the filter holder
correctly and rotate firmly
as far as it will go.
Have the espresso boiler
gasket elasticity replaced
at a service centre
Clean the spout holes.
Wait until the OK light
comes on not on when
the coffee switch was
pressed.
Preheat as described in
the paragraph "Preheat-
ing the appliance".
Preheat the cups by rins-
ing them in hot water.
Fill tank
Insert tank correctly.