Download Table of Contents Print this page

Hot Water Production - Whirlpool ACE 010 Installation, Quick Start

Hide thumbs Also See for ACE 010:

Advertisement

Table of Contents
IMPORTANT: always clean the cappuccino
maker after use. Proceed as follows:
1. D
ISCHARGE A LITTLE STEAM
rotat-
ing the
steam
knob.
This
emp-
ties any
milk left
inside the
steam spout.
IMPORTANT: To ensure hygiene,
you are recommended to follow this pro-
cedure each time you make cappuccino to
avoid milk stagnating in the milk circuit.
2. W
,
ITH ONE HAND
HOLD THE CAP
and with the
PUCCINO TUBE FIRMLY
other unscrew the cappuccino
maker itself by rotating clock-
wise and extracting downwards.
1. T
by pressing
URN THE APPLIANCE ON
the ON/OFF button. Wait until the
OK indicator light comes on.
2. P
under the cappuccino mak-
LACE A RECIPIENT
er.
3. P
and at the same time
RESS THE COFFEE BUTTON
turn the steam knob anticlockwise.
Water comes out of the cappucci-
no maker;
for a few seconds by
-

HOT WATER PRODUCTION

3. R
from the steam
EMOVE THE NOZZLE
tube by pulling it downwards.
4. W
ASH THE CAPPUCCINO MAKER
steam nozzle thoroughly with warm
water.
5. M
the two holes shown
AKE SURE
in are not blocked. If necessary,
clean with a pin.
6. R
EPLACE THE STEAM NOZZLE
serting it onto the steam tube
and rotating firmly towards the
top of the tube.
7. R
EPLACE THE CAPPUCCINO MAKER
inserting it and rotating anticlockwise.
4. T
O INTERRUPT DELIVERY OF HOT WATER
steam knob by rotating clockwise
and press the coffee button again.
(You should not run off hot water
for more than 45 seconds at a time).
and
by in-
by
, close the
9

Advertisement

Table of Contents
loading

Table of Contents